Dansons Group AcuTron Control Board manuals and user guides for free. Read online or download in PDF without registration. Manuals Directory ManualsDir.com - online owner manuals library. Oct 18, 2013 Please refer to your product manual for complete operating and maintenance instructions. This information applies to all PelPro appliances—except the PP60—with AcuTron control boards.
Visit www.dansons.com/support for further technical assistance.
Thermostat Module
Feb 20, 2015 There's another thread on this board where the person ordered a new board. The board is a IV but the face plate said II. His board is the same number but a-V. Guess that makes mine one of the very early IVs being a -A. It is working properly now. The jumper seemed loose so I tightened the prongs inside with a tiny screwdriver. For which there is a separate service manual. You will find that while the repair and servicing procedures for 214 and ACCUTRON are basically the same. There are physical differences between the two. Primarily in the arrangement of parts. Unlike the ACCUTRON movement. The 21B movements be repaired.
1. Unplug the stove’s power cord from the wall outlet 2. Remove the 6 x 1/4” hex screws from the slotted back access panel 3. Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Unplug the 9 pin wire harness from the back of the board 5. Install the thermostat module by plugging it into the 9 pin plug on the back of the control board 6. Locate the thermostat terminal block marked T’STAT INPUT, found on the back of the module 7. Be sure to run the thermostat wires through one of the slots of the rear access panel before connecting the wires 8. Connect the 2 wires from your thermostat to the terminals on the module, 1 per terminal. Ensure the wires are firmly connected 9. Connect the 2 wires at your wall thermostat to their terminals. Ensure the wires are firmly connected 10. Reinstall the 9 pin wire harness to the 9 pin plug now found on the thermostat module https://montrealyellow520.weebly.com/mazda-6-2004-user-manual-pdf.html. 11. Reinstall the control board and the slotted rear access panels 12. Plug in the stove and you are ready to operate with your thermostat